A 25% Savings!!: When sold seperately, products total $37.50

Armorer's Kit: GROUND SHIPPING ONLY $29.95 or 3 for $74.88 (save 14.97) plus shipping  #91100

• Clean all surfaces of oil, powder/metal residues, rust, dirt, etc. using cleaners such as Gun Scrubber, Quick Scrub, alcohol or other solvents that does not leave a residue. Detail stripping, of the slide at least, is recommended. Allow cleaned surfaces to dry.
• Apply SMOOTH-KOTE one thin coating to all interior surfaces, including bore. Use brush, cotton applicators, dipping or spraying, etc. To treat the bore apply SMOOTH-KOTE a clean patch on a tight fitting jag and run it down the bore. One thin coating is all you want. The coating will dry in 2 or 3 minutes and cure in 2 hours at room temperature or when dry you can apply heat for 2 minutes with a hair dryer or similar. For quick clean up of SMOOTH-KOTE use alcohol pads.
• Use BP2000 POWDER to fine tune surfaces treated with SMOOTH-KOTE or TUF-CLOTH, such as trigger parts, rails and bolt, etc. Use a patch, pipe cleaner or applicator to rub BP2000 vigorously into the surfaces.
• Use HI-SLIP GREASE sparingly (a spot of grease about the size of a pin head) on high load or wear points such as locking lugs and the upper surface of hammer strut springs.
• Use TUF-CLOTH& to wipe exterior of firearm, magazines and magazine-well. To maintain firearm, after firing sequence, unload & inspect. Firearm can be cleaned with a dry, nylon-bristle brush.